Autocal tune loading instructions for 2001-2010. DURAMAX

RIDGE RUNNER DIESEL PERFORMANCE, LLC
3226 MAYBANK HWY – UNIT F4
JOHNS ISLAND, SC 29455
PHONE (854) 444-2874 – TONY
Email :orders@ridgerunnerdieselperformance.com

Autocal tune loading instructions for 2001-2010DURAMAX

***DO NOT UPDATE YOUR AUTOCAL***
Your Autocal is Pre-Loaded and has shipped with all
of the correct BBX files and firmware loaded.

Please plug your Autocal into the truck OBD2 under dash and turn key to “ON” or “RUN” position and DO NOT START and make sure the truck is not running.


*********** DISABLE ALL AFTERMARKET ELECTRONICS***********


Radio’s, Nav Units, I-Pod Adapters, Aftermarket Alarms/Remote Starters.

1. Using the “right” or “down” arrow press until “Tuning Tool” is displayed, press “OK”
2. Press down when “Read” is displayed, press down  again until “Program Full” is displayed and press “OK”
3. Press “down” until the tune “2_RRDP” is displayed,  press “OK”
4. At this time you will be asked via a message to “license controller?” then press “OK”, when prompted “are you sure?”  Press “OK” a second time.
5. Flash will begin and take approximately 3-9 minutes depending on the controller being flashed, after completed you will see a message to “turn ignition off”, do not turn off until you see the message at that time press the “OK” key and wait at least 15-40 seconds depending on the controller being flashed for the counter to finish.

Congratulations you have completed the first step.

 

 

Step 2 : Changing your custom tunes if more than one set of custom tunes are pre-loaded.

NOTE: If only a “1_STOCK_TIS “ and a “2_RRDP” is loaded disregard this second step unless you want to return the vehicle to “STOCK”

1. Please plug your Autocal into the truck OBD2 under dash and turn key to “ON” or “RUN” position and DO NOT START and make sure the truck is not running.

*********** DISABLE ALL AFTERMARKET ELECTRONICS***********
Radio’s, Nav Units, I-Pod Adapters, Aftermarket Alarms/Remote Starters.

2. Using the “right” or “down” arrow press until “Tuning Tool” is displayed, press “OK”
3. Press down when “Read” is displayed, press down  again until “Program FULL” is displayed and press “OK”
4. If retuning or returning to stock then follow steps 5 and 6.
5. Press “down” until the tune you want to load is displayed, and then press “OK”
6. Flash will begin and take approximately  1-4 minutes, after completed you will see a message to “turn ignition off” at that time wait at least 15-40 seconds depending on the controller being flashed for the counter to finish.

Congratulations you have completed the tuning; you can use “Program Full” or “Program Cal” at any time to change to any of the tunes by following Step 2 of these instructions.

For 2004.5 LLY thru 2010 LMM only a “Program Cal” is required for updates to DSP5 Tunes.

2001-2004-LB7 requires a “Program Full”.

Please follow LB7 specific flash instructions to prevent a controller from becoming inoperative.

NOTE: Return the ecm to stock please use “Program Full” and select

the “1_STOCK_TIS” tune

 


Leave a comment

Please note, comments must be approved before they are published